Effective Solutions with StormChamber

Residential Reuse And Water Use Restrictions

Supplies of fresh water are shrinking not only in the USA, but throughout the globe, resulting in steeper prices for water rates. Stormchamber systems are easy to modify for water reuse by lining the trench with an impervious plastic sheet liner and a pump.

Benefits of using the StormChamber system FOR WATER REUSE include:

  • Cost efficiency. A low-cost alternative to traditionally utilized reuse systems.
  • Out of sight systems traditionally used for environment storage volumes require unsightly large storage tanks adjacent to the home.
  • Large storage capacity. One installed Stormchamber will hold approximately 1,200 gallons. About 10 inches of rain over spring and summer on an average 1,360 sf roof would yield 8,160 gallons of rainwater. A typical rain barrels holds 55 gallons. That would require 148 rain barrels versus 7 Stormchambers.

Rain Water Reuse and Conservation system

A StormChamber water reuse system allows you to collect water through the roof, which is then transported through the gutters and downspouts to a filtering system underground. Water will be stored for future use. Benefits of selecting StormChamber to fulfill your stormwater management BMP needs include easy installation, cost efficiency, and fresh water conservation.

Residential Water Reuse

Testimonial

  • “Because we have installed several StormChamber systems, a lot of engineers have asked for advice on competing plastic chambers. We have always recommended the StormChambers. They far exceed the competition on cost and ease and speed of installation.”

    Dean Clark General Manager, SECO, LLC, Chelton, WA

  • “Much less expensive and much quicker and easier to install than the 64″ pipe originally speced for the project.”

    Joe Szabo Owner, J&R underground contractors, Milan, MI

  • “Significantly faster and easier to install than pipe. Significantly less staging room needed and a lot fewer trucks to receive and unload.” (The equivalent of 213 LF of pipe nest on one pallet, 1,913 LF on one truck.)

    Bob Dawson Owner, Dawson Company, Woodbridge, VA

  • “We have installed several StormChamber systems because we find them to be a lot less expensive and quicker to install than the competing systems and we can install them in two layers on very confined sites.”

    Ed Shaw Shaw Construction, Reno, NV

  • “We were surprised by the ease of use of the system and greatly appreciated support provided. We are already looking forward to building our next StormChamber project!”

    Erik Gervais PE, Constructions GFL, Brossard, QC

  • The Loudon One project in Ashburn, VA

    “I also like that it can be cleaned by air vacuuming via inspection /cleanout ports instead of using water. Anytime you have to clean something with water, then you have to have a truck that collects the water and the sediments in it. Depending on where you can dump that, it can get much more costly as opposed to going out with a vacuum truck.”

    Steve Pandish Director of Water Resources for the engineering firm of William H. Gordon Associates in Chantilly, Virginia

  • HUGO SIMS METAL RECYCLING FACILITY IN THE BRONX, NY

    “The choice of StormChambers met the design requirements for strength in such a way that the chambers could be stacked three deep with 30 feet of cover, if needed. Strong enough to sustain the impact of 18-wheelers loaded with steel. They also were 30 percent more cost-effective than other options.”

    Dr. Paul Mankiewicz hydrologist and consultant to the City of New York on storm water and related issues and executive director of the not-for-profit Gaia Institute in the Bronx, NY

  • Double-stacked system in Tukwilla, WA

    “It was easy. There were no difficulties once the owner decided on the StormChamber system. The project is holding up to heavy traffic, pump tracks, and cranes.”

    Tom Radice Abbot Construction

  • Charles-Lemoyne Hospital, Greenfield Park, Quebec

    "We were amazed by the simplicity of this system and have appreciated the support from the Soleno team during the entire project. We are already looking forward to designing another project using the StormChamber!"

    Érik Gervais, P. Eng Const. GFL, Brossard, Quebec
Submit Your Design
NDS DesignWorx™
NDS DesignWorx™ Team is available at every step of the design process. Let us take out the guesswork and show you how NDS products can help meet your project's specifications, reduce costs, or save time.
Submit Your Design
Request a Lunch and Learn
Learn about the New NDS Stormchamber Line Directly from an Expert
Request a Lunch/Breakfast and Learn, Webinar or One-on-One Meeting...
Request Lunch and Learn